Mastip iB6 Podręcznik Użytkownika Pobierz pdf (Strona 19)

Temperature Controller iB6 / iB12

Priority Code Condition Controller

Response

How Alarm Is Cleared

1 OVt Internal over-

temperature

All outputs off Turn off controller; make sure

fan and vents are not blocked;

wait for controller to cool; turn

on controller; if error recurs,

contact technical support

2 ER1

ER2

Problem with

controller’s internal

operation

All outputs off Cycle power to controller;

if error recurs, contact the

Mastip technical support at

[email protected] or your

local distributor

3 TCr Reversed thermocouple

detected

Zone goes to

configured failsafe

state

Use

button to put the zone

in Idle as described in 3.4.3,

and then after problem is fixed,

put zone in Normal (closed

loop) or Manual (open loop)

mode

4 SAF High-temperature

safety limit exceeded

(configured in Superv.

Config menu; default is

feature disabled)

Zone output off if

feature is enabled

5 TCo Open thermocouple

detected

Zone goes to

configured failsafe

state (configured

in Superv. Config

menu)

6 LPB Loop break detected Zone output off

7 HID High deviation alarm Zone output off Clears automatically when

alarm condition clears

8 LOD Low deviation alarm Zone output on

9 Tu0

Tu3

Tu5

Tu8

Tu9

Autotuning error Zone output off

Use

button to put the zone

in Idle as described in 3.4.3,

and then after problem is fixed,

try tuning again

For more information about

tuning and Autotuning errors,

see Section 6.

4.5 Alarm Priorities

If a zone has more than one alarm condition, the code for the highest-priority alarm is displayed.

Alarm priorities are in the table below.

4.0 Alarms & Alarm Indication

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Komentarze do niniejszej Instrukcji

Brak uwag

Mastip iB6 Podręcznik Użytkownika Strona 19

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Mastip iB6